render the graphic window

[sml2011]

Hi

 

Can you please tell, how can i have better tool shape when i use verify window?

 

Please sea attached picture.

It is my tool that showed in verify window but it is not a circle it is a polygon.

 

How can i have better tool shape in verify window?

 

 

Thank you

[Richard Thomas - Mastercam UK]

When you are using Verify there is a sliding bar that has "speed" at one end and "quality" at the other. Place the slider closer to "quality" for a smoother tool shape (using more lines).

 

Another option is to go into the Verify options page and reduce the value called "tool tolerance". The defaut value is 0.008 (metric). Be warned that this could slow Verify down significantly!

[pip]

In verify move the display controll slider to the right (quality ).

[Mark H]

... The defaut value is 0.008 (metric).

 

Rich, are you saying that even if I'm running everything in Inch that Verify is using .008 metric?

[Richard Thomas - Mastercam UK]

No sorry Mark, I'm just saying that the default value when using metric units is 0.008mm. I didn't know the inch value offhand, for when you are working in imperial. Interestingly I've just checked the imperial default and it is 0.008 as well. I would say that that is 0.008" when in imperial units. Same advice about reducing that value will apply.

[Mark H]

Ok thanks for the clarification. And yes .008" is the default, the smallest allowable value is .001".

[NOTW Programmer]

Last I checked that was .008" (inch) not metric, but I could be wrong.