dell m90 video driver

[phil darcy]

I had to reformate my m90 drive and lost my video driver for fx-3500m card.

I have tried a handful from dell and solidworks sites.

Mastercam is what causing problems with back plot.

It leaves all the back plot moves and they stay,through restart,repaint,ram saver,etc.

My hope is someone has a driver # thats works for them.

 

Thanks,

[Jayson Kramer]

Are you sure the backplot moves are not Geo now see if you can pick it..

[phil darcy]

Are you sure the backplot moves are not Geo now see if you can pick it..

No Jay they are not geo and they stay on all level.

I can't figure out what I before,I had recorded the driver # before reformating

and the # was for 64bit xp and I have 32bit?

[gcode]

I always get my drivers from Nvidia

They have a search function. Try running it and see what driver it recommends.

Your siggy says you are still running Vista??..

You may need to go to the graphics performance page and turn off some of the eyecandy

 

 

[Jayson Kramer]

The Nvida site now has a option for it to check scan your computer and tell you what you need give it a try.