X6 Operation not found

[Bill Henderson]

I get this error.

 

But I hit ok and it continues as if nothing was wrong.

 

I have X6 loaded along with X5. I did the utility update.

 

Could it be a default change that was made?

[hayduke]

I get this error.

 

But I hit ok and it continues as if nothing was wrong.

 

I have X6 loaded along with X5. I did the utility update.

 

Could it be a default change that was made?

I get the same error. Called the local rep and he got the answer to correct it.

Go ahead and click OK, then fill out all the parameters, up in the left hand corner

you will see a floppy disc, click it and you will start saving the parameters as your defualts.

You will need to do the same for each type of toolpath.

[Jon H @ In-House Solutions]

This is likely happening because you migrated your settings from X5 to X6? You may notice that in X6 there is a drop down menu when you select Surface Highspeed (and you can then select your toolpath from there). In X5 however, you could only select Surface Highspeed and would then select your toolpath from within the parameters page. That is what I think is causing the warning message. If the above solution does not work, you could ask your reseller to send you their mill_inch.default file and if you replace that with your existing one, you will no longer get that warning.

[shazam/TPP]

or just read this thread to get back to original (virgin) default files and then tweak them to your needs.

My link

[Pilot Plant Supervisor]

I had this issue too. My re-seller said it was because I did the install as "user" instead of "admin". I had our IT dept. un-install and re-install as admin, and the problem went away.