X7 xform rotate ?????

[thanhsonnguyen]

i have prolem on x7 xform i want rotate y to x , but it move become X TO Z I USE MANY YEAR X6 NEVER HAVE THIS , SO ANY LUCK or x7 have change new????????????

[K2csq7]

Are you sure you are in the right plane?

[CADCAM3D5AXIS]

[thanhsonnguyen]

i use this in x6 or last version many year not see any prolem ,isit x7 change new

exp: file long part ( what ever when you open it stay long side on y and i want move long side to x ) so i use xform rotate it not see this prolem on x6 or x5, but x7 it from side x down z ,not move on x and Y

[thanhsonnguyen]

so x7 now change i try make plane same view with gview and it ok - anyway thank you for you guy help

[JoshC]

There should not be any differences between xform rotate in X6 or X7, like K2 said above, perhaps check your planes. An alternative to checking your planes would be to try a Dynamic Xform, pick your rotation point then highlight the X, Y, or Z of the gnomon until only the two axial legs of the gnomon are highlighted and pick, then just spin the part and / or type your rotation value. Hope this helps

[thanhsonnguyen]

there lick on this will be same x6 very time no need check plane ,i findout now same at x6 ( i can't post pix ) but there on setting -cad setting -lick on update cplaneandtplane - reset cplane to top .....

[MotorCityMinion]

Holy F-in Icons. Why not add a forth row tool bar to the top. Using a 30 inch monitor by any chance?

 

Brought to you by Makers Mark, not watered down! Buuuuraaaaaap.