Okuma Multus Spindle Help

[heavymetal]

OSP-200

Does anyone have a main/sub spindle, X/Y-axis, zero set procedure they can share?

 

TIA

[crazy^millman]

Best to call your machine builder or supplier and get the procedure from them.

[heavymetal]

Got one from our supplier but it's vague and hard to follow in some areas.

[mkd]

I have a nice macturn H1 turret zero offset plus a multifuntionassistant.pdf, but nothing for main/sub

[crazy^millman]

2 hours ago, heavymetal said:

Got one from our supplier but it's vague and hard to follow in some areas.

Then you might need to call them in and have them walk you through it and document them doing it so you can make your own. I did that with Thermwood years ago. I called them in once and watched the process. I asked questions took notes and was able to do it myself from that point forward. I have done that one many other machines, but the Multus is one where you need to get the specific process correct or run the risk of tearing something up.

[huskermcdoogle]

3 hours ago, heavymetal said:

OSP-200

Does anyone have a main/sub spindle, X/Y-axis, zero set procedure they can share?

 

TIA

Are you just zeroing, or fixing alignment of the above components? If you need to correct zero due to a crash most certainly you need to check alignment as well, I would highly suggest getting a tech in to train you.  Lot more going on there then meets the eye.