What Happened to the Tree in Machine Config?

[Reko]

I went into the Machine Def in Mastercam 2018 to change the A-axis setting from 0-360 degrees to continuous... but the tree does not have the A-axis in Mastercam 2018.

I checked and it was there in 2017... I did a normal migration, so I don't think I messed anything up... did they put the settings from the tree somewhere else in 2018?

 

[Reko]

Anyone else seen this in MC2018?

If you have a 4 axis post... where do you change from 360 max degree output to Continuous?

[crazy^millman]

See the little Plus sigh? Click on it and it will give you the tree.

 

It is just collapsed is all.

[CJep]

8 minutes ago, Reko said:

Anyone else seen this in MC2018?

If you have a 4 axis post... where do you change from 360 max degree output to Continuous?

Reko right next to the Y axis of the machine tree there is a plus sign, you just need to open the rest of the sub pages.

Right click on the machine base and use the expand all.

 

[crazy^millman]

1 minute ago, CJep said:

Reko right next to the Y axis of the machine tree there is a plus sign, you just need to open the rest of the sub pages.

Right click on the machine base and use the expand all.

 

I was faster than you.

How are you doing?

[CJep]

1 minute ago, C^Millman said:

I was faster than you.

How are you doing?

Doing well my friend, how are you?

[crazy^millman]

Just now, CJep said:

Doing well my friend, how are you?

Good as can be expected. Better than I deserve.

Least I can hit the plus sign on a tree to un-collapse it. J/K Reko.

[Reko]

Dang it... I can't believe I missed that!

Oh well, at least I brought you two old mates together for a chat.  

Thanks guys! 

[CJep]

thumb nail: