43 minutes ago, AHarrison1 said:

Well, I've given this the obligatory 30 min while the boss isn't looking and I cannot reproduce what you are seeing.

Well done!!!!!!!!!

This usually happens when you are using a custom plane in a toolpath. In the planes manager click on the Top and turn the WCS on for Top.

Read here on how Inverse Time feed rates are calculated. 

 The

I checked by posting some code and that is not affecting the code, no need to change the maxfrinv

Your control definition is set to Degree/min for the 4th axis rotary in the file you linked. The Max Inverse feed rate is set to 1000 in the Machine definition. The post has a 0 value for the maxfrinv value as well.

There isn't anything in that file?

Here is a link to the one I created. I have one with the housing and one without. This has the housing

https://www.dropbox.com/sh/3i6a75w8cu2knm1/AADM1k7Yi2khLNp8CH7xQwOva?dl=0

I made a DNM4500 Machsim and it worked fine. What solid model did you use for the machine?

Copy it to a new level and see if you alter it. Other option is to remove the history on the model with Model Prep.

You are trying to alter the wireframe geometry that drives the solid model most likely. 

3 hours ago, n0xx187 said:

Wish I could get that Post for MasterCam 2021... Havin a heck of a time getting a Haas VF2 with 4th axis Post

Your re-seller will have access to a Generic Haas 4 axis post through the Post Install tool.

The best part about buying a new post would be getting support....

2 hours ago, gcode said:

three failures this morning

can't even get in the front door 

Thank you for paying your maintenance......these "un documented features" will be addressed in a future release!!!!!! :D~~~~~

Divide by 2!!!!!  

Not sure but the rod has always been cheaper and easier to get.

See the photo.

On 4/11/2023 at 8:12 AM, So not a Guru said:

With the Verify window open; File/Options/General/Collision Checking  make your selections.

MC2023 is in a different location? 

Change "Source" from "Geometry" to "NCI"

Click on “Verify” when in the verify window. Then drop down “Material Cutting” and make your selection. 

I would suggest Unified Morph's for most of the finishing. Equal Scallop in the areas on the ends using 3+2 positioning. Others might have better suggestions!!!

This is likely due to a limit set in the post or in the misc integers

Look in the post for " lim_rot_inc". This could be set at 22.5 instead of 45.

Also you can try making this change as shown in the photo to see if that will help.

What version of Mastercam are you using? I doubt this entire part can be cut on a 4th axis. 
 

If you post a valid Mastercam file with the part setup and some toolpaths people will help you. 

26 minutes ago, Jobnt said:

Maybe this is the persuasion I need

What it isn't Vodka?????

Big thank you to In-House Solutions!!!!!

There is a drop down where you select to create the Stock Model. There is an option for Pmesh there.