Thanks for the link!

Thanks for the reply's I have one more question, How do you Calibrate the presetter arm?

Hello gentlemen, I was woundering if any of the experienced Haas lathe users could answer a couple of questions: 1.When using the touch probe,and touching off a drill, do you just Key in the X offset of some neg number to get it to center line? Can you sweep the ID tool holder in and calc that position as X0 in the G54? Will it screw up the presetter?(that way if you want it to go to center, you leave the X offset 0) 2.Is there a position you can set where the tool always rapids to for indexing, like a G30 in Fanuc? Thanks for everybody's time!

Emuge taps will do the same thing

Right Click in the operation Manager

So these are seperate programs for the upper and lower turret correct?

What post are you using?

I believe you can if you rapid the Z out in front of the part, then cancel.Been doing it for years

So if I had a old hasp, and running Ver 9, how could I set a USB port to use the old 24 pin hasp?

Change at point,change the X dim of an endpoint in a tool path without changing geometry.

Been running it for as long as X2 has been released, no problems at all

You I did a search, and nothing came up. Thanks for the info John

Is there a current hasp driver for Ver 9.1 to work with vista? I have read in this forum and other forums about vista.(has not beed very good) Thanks in advance

Hello everyone, I did a search on set-up sheets for lathe work(did not return any results) I was woundering what everybody uses or prefers? Thanks in advance

Thank you Sir