Thank you.

Just found this on the update page. Has anybody installed this? quote: Download size: 23.6 MB , 3 minutes Microsoft .NET Framework 2.0 Service Pack 1 provides cumulative roll-up updates for customer reported issues found after the release of Microsoft .NET Framework 2.0. In addition, this release provides security improvements, and prerequisite feature support for .NET Framework 3.0 Service Pack 1, and .NET Framework 3.5. After you install this item, you may have to restart your computer.

quote: If only Member #2962 could've been lost. -------------------- He was close. I was member #2662 and was corrupted.

Clicking on MCX2 icon or a mcx file will not open MCX2. I click on the MCX2 mr1 sp1 executable to do a repair and that didn't make a change. Can I reinstall from this point or do I have to start from MCX2 disc and install mr1 and then sp1? I'm all set. I took the plunge and removed Sp1 then Mr1 and reinstalled them and now I'm good to go. [ 09-24-2007, 08:06 AM: Message edited by: Guy Arseneault ]

Thanx will do. I did download it but did not notice that section.

Is there a formula to achieve a certain numbered finish?

quote: removal where I leave .01" on verticle walls and cut to depth. Are you also leaving .01 on stock to leave on floors?

I get that also. I set my stock size on the toolpath page. HTH

I'd help spinner, but I don't have a 5 axis license. How's it going for yah? I see your movin' up in the world. Welcome to the forum. Lot's of info and help is at your fingertips.

My bad. Should've checked before opening my mouth. But that would be a nice feature though.

In ver9, you could select which surfaces you wanted translucent.

Read your post Jim and did what Roger stated to do quote: What 'fmt's are assigned to i$, j$, k$ ? fmt I 2 i$ # Arc center description in X fmt J 2 j$ # Arc center description in Y fmt K 2 k$ # Arc center description in Z and BINGO it worked. Thanks again to Roger and Jim for your assistance.

Do I need to do something else? pcir$ # Circular interpolation n$, sgplane,e$ if plane$ = 0, n$, sccomp, sgcode, *x$, *y$, z$, *iout$, *jout$, kout$, pfr,e$ if plane$ = 1, n$, sccomp, sgcode, x$, *y$, *z$, iout$, *jout$, *kout$, pfr,e$ if plane$ = 2, n$, sccomp, sgcode, *x$, y$, *z$, *iout$, jout$, *kout$, pfr,e$

I just did a file compare of my ver9 post that I used to update to X and my current post I'm using for X2 MR1 SP1 and the only difference was quotation marks and dollar signs.

This post ran fine in X2. I will check this post to the original I updated for X.