Thank you Ron

thanks David

thanks ,one more question.The tool run center of the surface ,what to do to have a option run the tool edge to the edge of helix ????

thanks ,one more question.The tool run center of the surface ,what to do to have a option run the tool edge to the edge of helix ????

thanks David ,works

Guys ,

why Morph between 2 curves run  along the edge only on 5axis .If  I switch on 4th run across???

thanks guys

Thanks one more time

David,

on your first  example I have tried set deep of cuts , and did not work correctly.if this example is used to finish only some 5 axis contour,or the is other tricky ????

David Colin ,

thank you very much for your help

Good morning everyone,

I would like learn the basics  the 5 axis curve toolpath  .I did sample but I am doing something wrong. .Could someone help my ???

I would like to do it on 4tx axis.

Thanks for any suggestions

thank you JParis for reply ,

only rotary motion run slow ,I tried also G93 .I see on the control  the line of  program   move slow.

Hello all,

I did  start  job on 4th axis yesterday on Haas VF 8 .The program was to long send to the control so i had to run from Fnc mode (from USB flash drive).

the program run very slow .machine cycle time is 4 times longer than on on mastercam.I think that this is something with control .There is something that I can change

myself on the control  ????

Thank you for all the advice

Look here, sound be able to get going.

Lots of info

http://www.emastercam.com/board/topic/36166-dnc-to-haas-using-usb-stick/

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Thank you Hardmill  , it works

 

 

 

 

 

 

 

PEACE

 

if anyone knows if there is an option run program from USB flash drive on hass  VF 8???

thanks

you're welcome

HERE YOU ARE

setup clemps.SLDPRT

no, no, I will ask for toolpath my  reseller , someone did for them solid  ,then    I hope   they will help me   with   toolpath  . I wonder what they answer. Thank you Murlin .

exactly

new

Murlin ,maybe I have something wrong in my  stings ,I do  filet an your file and do not make filet on  middle of part

ok I'm sorry ,first I ryour email

after flat boundry

this is after flat baundry

I know , but look at the lower part ,when i trim the surface i want make flat boundry show mi the chain is not close .

surfaces