Get gap Id in event log causes lag

[Guest]

12 minutes ago, crazy^millman said:

All created locally and no I cannot import into a new file a lot of OPS tied to Solids. I see this on every 2021 file I have made that existed from a previous version or with everything done only in 2021. I have asked QC and they were checking with the developers to get me an answer and I haven't gotten one back in almost a month as you see the time stamp on those screen shots sent it. 

Okay, thanks for all the info, i'll see if I can duplicate this.

[Leon82]

On mine there is only 1 path tied to the solid, a drill path

[Leon82]

I did a report. The planes go from 50 to 72.

 

When I deleted the entire 1st rough operation group it seemed to lag less but still ran the cursor busy. This group had 2 toolpath groups in it. 1 for each side.

[crazy^millman]

50 to 200 planes is pretty normal.

This morning same issues. 

[Guest]

3 hours ago, crazy^millman said:

50 to 200 planes is pretty normal.

This morning same issues. 

I'm looking into it, the plane class has undergone some changes recently, I don't expect to make any headway on this until early next week, I am still gathering information.

[crazy^millman]

1 hour ago, byte said:

I'm looking into it, the plane class has undergone some changes recently, I don't expect to make any headway on this until early next week, I am still gathering information.

Peter Thank you for looking into the issue.