2d contour mill Multipass aircutting

[Jobnt]

8 minutes ago, Newbeeee™ said:

Anyway - where's the OP?

Trying to figure out why this ended so badly for him and trying to find a way to come back and bash us some more and not get his xxxx handed to him again. 

8 minutes ago, Newbeeee™ said:

Is it too early to start drunk posting

 

Never. You can't drink all day if you don't start in the morning. 

3 minutes ago, gcode said:

it's 5 oclock somewhere  

Said no red-blooded Irishman ever. (We don't need excuses like what time it is. And we don't mind drinking alone)  

[Newbeeee™]

2 minutes ago, gcode said:

it's 5 oclock somewhere  

Outta likes - I'll have to approve your post tomorrow!!!!

[gcode]

19 hours ago, Newbeeee™ said:

Anyway - where's the OP?

Finishing up at his day job at Aerospace Deburring and Metal Finishing

He'll be checking in for his key board warrior gig any minute.

[AHarrison1]

21 minutes ago, gcode said:

itting by the pool drinking gin and tonic

...hmmmm... mothers milk...

[cruzila]

OFF THE RAILS!!!

My best time I have spent in the industry was the 10K plus hours spent Machining (I.E. turning handles) prior to ever learning how to run a computer. I might have 20-30K hours in CAM, but so much of that was programming while watching chips fly. Nothing more exciting than shooting big copper chips halfway across the building.

Can we have that debate about manual vs automatic??? Again............