A question for 5 axis users

[wildcat99]

Backplot and Verify here too, although Verify is a challenge to use with the watertight issues. I'm hoping this will all be better in X.

 

For one-off patterns and molds, I check the gcode at the start and end of each operation for clearance problems. If needed, I add a clearance op in Mcam or change Misc values and repost until I get what I want. Or for the sake of time, I just edit the code or add a couple of lines for clearance.

 

Once the cutter is in the part, no worries, it's the transition moves between ops that I look at closely before going to the machine.

[MATT Q]

I use the backplot in wireframe like what Jimmy is talking about and it seems to work well hopefully verify will work better with x.

[mman10]

We use Backplot and Verify and sometimes Camaix and lots of caution at the machine because of MultiXpost.

[David Czerw Triumph Gear Systems]

Veri-cut all the way. Not only can you see exactly what your machine is doing. Its the little thing that you dont realize. You can define your holders run with one if it hits or rubs anything you will be notified. Change holder or stick out and run till no more errors.It will even tell you a min. projection for each tool. I use it with the mastercam c-hook all the time. It will also tell you of any gouges or extra material anywhere on the part.

[NCGUY]

Hello,

 

My name is Mark Benedetti and I am a Sales Engineer for CGTech. I handle the Michigan and Ontario area. I have been with the company for over 12 years and have seen just about every CAD/CAM, simulation, and verification company that has come and gone.

 

If you have any verification questions I will be happy to answer them the best I can.

 

In short, VERICUT is much more than a verification software.