HELPPPPP(!) and i hope someone from cnc read this post

[Elad]

I am tired of the message : "The magenta toolpath is only a simulation of the control's path..."

i can't see this message anymore. all day i program with mastercam and i am really tired of getting this fu*#%n message!!!!!

How do i get rid of it???????

after 10 hours infront of the computer i can't see this message!

[Storkman]

Gotta agree, that gets pretty annoying. But if it wasn't there, I would prolly be upset. (Why didn't it tell me that comp wasn't on in the computer? )

[Pete Rimkus from CNC Software Inc.]

Elad,

 

Sorry - can't help you there. No way to turn it off - unless of course you switch to "cutter compensation in computer".

 

I recommend getting up from the computer, walking away, fixing a cup of tea (or whatever your preference), and when you return to the computer, calmly typing an email to qc@mastercam requesting that this message be made optional - including your ideas on how you think this should be implemented.

[Storkman]

Tea Pete???

 

 

[Pete Rimkus from CNC Software Inc.]

Whatever your preference...

 

Remember - I'm trying to calm him down.

[gti_jay]

solution:

 

Convert to center path programming.

Use wear offset.

 

You'll never see the message again!

[spade117]

Yeah I use wear and I have never seen that message before.

[Elad]

Pete,

 

I will email to qc.

it became like this messages you have when you install a demo version : "you now have 5 day to register..."

and you get this message 50 times a day!

A cup of tea wont calm me down!!!!!

[ak762]

Elad,

I asked before the same here

http://www.emastercam.com/cgi-bin/ultimate...ic;f=1;t=016621

 

Seems nothing change still