Stock size in verify settings acting funny

[Thad]

I'm doing some 3 axis machining for the first time since installing X2 MR1 SP1. I have my stock setup in verify to use last size. The numbers could be anything when I launch verify for the first time in a session, so I set them for my current job. After verifing, if I create another toolpath and verify again, the stock settings should be what I just set them to....but they're not. All fields get reset to zeros. Is anyone else seeing this?

 

Thad

[DaveR]

All the time, sometimes I get $$$$$$$ in the min max fields and the message "stock size failure" or something to that effect, blank simulation area.

 

I always have to set the stock size every time I simulate, even if I've set it up in the ops manager.

 

Drives me nuts.

[Guy Arseneault]

I get that also. I set my stock size on the toolpath page. HTH

[Columbo™]

same here

[Thad]

I've used "last size" for a long time with zero problems. When X came out, it was still checked as my default but there was a bug that caused it to not be read. It was just fixed in MR1 and now it's giving me problems.

 

Thad

[gms1]

Occasionally this happens to me as well. And by the time I see it I've moved on and don't remember the steps I did to get the $$$$$$. Most of the time it works fine with my stock definition or by rectangle/circle.