Peel Milling X2-MR2

[Wise-ACR]

I am getting an error "2D High Speed" not found in your operation defaults file.

 

Anyone know what this means.

[3R!< W3NG3R]

You have to go into your ops manager and add it there (with defaults if you like)

[Colin Gilchrist]

Ignore the error. It is telling you that there is no operation default available for the peel mill. Just click "ok", fill out the property pages with some parameters, then right-click on the tool parameters page (in the grey area, not on a data entry field), and choose "save parameters to defaults file".

 

This will create a peel mill operation default for you.

 

HTH,

[3R!< W3NG3R]

Yes, Colin's way is easier.

[Troy Gossett Indepak Inc.]

Hey great tip Colin, it is a pain to go all the way into ops defaults to do this.

[cobra95kev]

If this toolpath is anything like Surfcams trumill it is going to be kickin.

 

I am talking my employer back in to getting on Maintenance just for this toolpath. I can't wait to get this one.

 

Kevin C.

[Glenn Bouman]

It looks like there is a problem with Peel Mill and HST toolpaths if you migrated your settings (Mill_Inch.DEFAULTS)from a previous install.

 

You may notice with Colin's method that the view changes during backplot of a Peel Mill toolpath and you may get an A0 posted out with some posts.

 

Using the Mill_Inch.DEFAULTS that came with the install does not cause this problem.