OT Problem HAAS Control and Errors

[jspangler]

Hi

I don't know what i did, but i am having problems running programs I created in V8 level 1 mill, stored on My Haas VF-2 control, and actually ran before. Now when I try to run programs, I can't use cutter comp or wear comp or i get errors, and on certain programs i've ran previously with no problems, i now get "invalid I,J,K" errors. Keep in mind, these were all programs that ran FINE before, and are stored on the control.

 

What Happened??

 

Help

John

[kccadcam]

Has anybody changed any parameters in the machine at all???

Even a service rep maybe??

If the programs have never left the control then it's got to be something in the control itself.

Start checking parameter pages.

 

Another excelent reason to always backup your machine parameters!

[Trevor Bailey]

Make sure that no one added the full diammeter of the tool being used in the offset page instead of .001 +/- and so forth. I have seen this be a common mistake. Especially if you have run the program before. Also, if you are using a regrind, make sure that you are not comping too much for the arc.

[Scott Bond]

Hi

Look at all parameters, and make sure all are set to 0 .

Even on the tools that are not in the program your presently running.

Email me if you need more.

[RandyN]

bla, bla, bla, sorry I posted before I read your post correctly.

 

Move along, nothing to see here.....

 

[ 06-07-2002, 06:12 AM: Message edited by: RandyN ]