TOOLPATH REFINEMENT SETTINGS DO NOT STICK!!

[Mr. Wizzard]

Ok, i read through every previous post i could find on the new toolpath refinement feature.

I decided to start playing with it today to test settings and code output. I'm trying to track the code/nc file i get for different settings.

I cannot get anything to stick repeatedly. Set the sliders, hit the green check, go back in and everything is different. WTF?

Is there something i am missing???????

 

X4 MU2

[peon]

Never stuck R&D. I was hoping it would have been fixed in MU3, but it hasn't.

[JAMES GABEL]

My question is when you set it and get out does it post the refined tool path?

[MotorCityMinion]

You should see the difference in Back plot with end points enabled, prior to posting.

[Mr. Wizzard]

Is the toolpath refinement adjusting the output?

I assume so. I can see the difference in backplot with changes to the number of arcs vs. linear moves.

Question is, what setting did it use?

I can backplot the toolpath. But when i go back in to check the settings, they are different than the ones that showed on the screen before i hit the green check and regenned the op.