Dogleg rapid move

[BenK]

Inside a drill cycle is there a way to avoid a dog leg rapid move?

[Müřlıń®]

That is your control that does that...

 

Don't think so....just add the clearance on all paths.....

[Mic6]

Set your rapid>feed in the MD/CD.

[Müřlıń®]

Set your rapid>feed in the MD/CD.

Wow you may be on to something.

 

Take out the G00......you could hard code that.

 

Does it dogleg on a G01?

 

The only other way that I know would be to edit the post where it would move the x and y separately .

 

I never tried to stop it. Just always did absolute.

[crazy^millman]

Yes it is the same principle Highspeed machining is using in feeding to the next place for a cut verses rapiding to the next place. By feeding you elimate all dog leg, but also get only feed rates. Might put a conditional statement in the post for rapid if it sees a drill cycle to always use feed rate instead of rapid. Then or course you have to worry about getting only feed rates on pecks.

 

HTH

[kool]

There is machine parameter that you can change to avoid dog leg move in rapid. i just can't remember parameter #.