Mazak Integrex 200-3s

[Shawn Wentzel- Wenteq Inc]

We have a 2004 Mazak Integrex 200-3s on the way and was trying to get a machine setup and built in mastercam. I keep getting errors. Does anyone have a baseline machine definition built so I can see how the 5 axis head and main/ sub spindles are to be set up?

[gcode]

You should talk to your dealer about the new MT module introduced in X7

 

http://www.mastercam.com/Products/MillTurn/Default.aspx

 

http://www.mastercam.com/Products/MillTurn/X7-MillTurn-brochure.pdf

[Shawn Wentzel- Wenteq Inc]

I did- and I was going to try it out because I was excited about it! I contacted my dealer and since it was not a new machine (They only have the Mazak 200-IV-S available) and he promptly sent me a machine info sheet. Once I filled it out, the response that came from CNC to my dealer was:

 

'This series is on the radar screen though it’s undetermined where on the priority list it might fall.

Once the machine is added then you can purchase Mill Turn. Again there is not time table for when this Machine might be added and you would be available to buy it.'

 

And that burst my bubble!

[mayday]

Just get ahold of In House. They have a good post and you don't need the mill turn to program it. We have 8 Integrex's old to brand new.

 

[mayday]

Just get ahold of In House. They have a good post and you don't need the mill turn to program it. We have 8 Integrex's old to brand new.

 

[Joe788]

I did- and I was going to try it out because I was excited about it! I contacted my dealer and since it was not a new machine (They only have the Mazak 200-IV-S available) and he promptly sent me a machine info sheet. Once I filled it out, the response that came from CNC to my dealer was:

 

'This series is on the radar screen though it’s undetermined where on the priority list it might fall.

Once the machine is added then you can purchase Mill Turn. Again there is not time table for when this Machine might be added and you would be available to buy it.'

 

And that burst my bubble!

 

Shawn, the MKIII should be very similar to the MKIV programming wise. It just has a Fusion control instead of a Matrix. The machine layout is still the same, and I'd expect the majority of the codes to be identical.

[Shawn Wentzel- Wenteq Inc]

Thanks for the help. I will call CNC and in house and talk to them both.

[mayday]

If you need some sample code for the Mark 3 let me know. We have the 3 and 4

[#Rekd™]

Call Jeremy at http://www.dbssolutionsllc.com/

 

He will get you setup.