Verify disaster!

[blue hootie]

Having a problem in Verify mode. Using X6 lathe. The drilling tool graphics are fine.

It displays the drills entering the part from the right side of the screen.

When it reaches a turning tool, such as an O.D. cut, the graphics rotate 90 degrees

so I'm looking at the face of the part and the tool is displayed cutting from the right

side of the screen when that tool should be cutting from the top of the screen.

Also, when all the tool paths are finished, you should be able to

rotate and zoom in and out on the part. I'm getting a warning message that says

"changing graphics view is not allowed at this time". fubar. anybody have any ideas?

[#Rekd™]

Can you share the file?

[DavidSV]

Are your planes set up correctly?

[blue hootie]

planes are correct. +D+Z

it's happening with or without stock recognition.

[#Rekd™]

A file will be required to sort it out.

[crazy^millman]

Does X7 do the same thing?