Jump to content

Welcome to eMastercam

Register now to participate in the forums, access the download area, buy Mastercam training materials, post processors and more. This message will be removed once you have signed in.

Use your display name or email address to sign in:

best way to remove old versions of mastercam

FTI2007

By FTI2007,
in Industrial Forum

 Share

Recommended Posts

FTI2007 Newbie

FTI2007

Posted
  • Author
Posted

I did the uninstall through the control panel for Version 6 but when I try to do it for version 4 I get a prompt that says... "installation source is not available. verify that the source exits and you can access it." ..... Im not sure what that means.  I also thought there were some files somewhere else that needed to be deleted also

Link to comment
Share on other sites
FTI2007 Newbie

FTI2007

Posted
  • Author
Posted

also without trying to get off topic but I see my hard drive is pretty full and I was going to run a disk clean up after uninstalling and deleting a few things I see it says I have 351 GB of Tempory Files. but the box is not checked to clean these.   Is it ok to do so??

Link to comment
Share on other sites
gcode Experienced

gcode

Posted
Posted

also without trying to get off topic but I see my hard drive is pretty full and I was going to run a disk clean up after uninstalling and deleting a few things I see it says I have 351 GB of Tempory Files. but the box is not checked to clean these.   Is it ok to do so??

normally, yes ... but DO NOT do it with Mastercam open

Link to comment
Share on other sites
gcode Experienced

gcode

Posted
Posted

I did the uninstall through the control panel for Version 6 but when I try to do it for version 4 I get a prompt that says... "installation source is not available. verify that the source exits and you can access it." ..... Im not sure what that means.  I also thought there were some files somewhere else that needed to be deleted also

If you've got the X4 discs available, launch install from the disc.

You may get an option to uninstall. If you don't, do a repair, then uninstall

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.

Join us!

eMastercam - your online source for all things Mastercam.

Together, we are the strongest Mastercam community on the web with over 56,000 members, and our online store offers a wide selection of training materials for all applications and skill levels.

Useful Links

Contact Info

Subscribe to eMastercam News

 

Legal

Privacy Policy

Store Terms & Conditions

Forum Guidelines

Follow us

×
×
  • Create New...