Okuma osp7 post help

[jeff]

My Okuma post is almost perfect,but I am still having one problem that is annoying.

It spits out an /M08 pretty much after every Z rapid approach and escape move.

On some programs this can be at least 100 extra times.

It doesn't hurt my program,but it really bugs me.

Does anyone know how to stop this,or should I have my dealer help me???

Okuma MpOsp7.pst is the post I am using.

 

[ 01-20-2004, 07:40 AM: Message edited by: jeff ]

[crazy^millman]

Lopok for a code definiton for the coolant. You then need to see on the pretract control section for this. If you see a * in front of that code just take it out and that shoudl take care of it.

 

Crazy Millman

[jeff]

Thanks Millman,I'll try that.

[crazy^millman]

No Problem Jeff if that doesn't work we can try other things just post up and I will try to help.

 

Crazy Millman

[Racer X]

Mine used to do the same thing. I have one that I would be more than happy to send it to you and let you try it out. It is for the OSP7000. Let me know if you would like it.

 

[ 01-20-2004, 01:24 PM: Message edited by: Moto GP ]

[Heavycut]

Jeff,

Try taking a look at

 

pzrapid # Linear movement in Z axis only - at rapid feedrate 0

n, pccomp, sgcode, z, pfr

n, pcoolon # Coolant on

 

also have different Okuma mill post if you need to take a look at.

 

Lathe I need to work on yet

 

Moto, do you have any suggestions on lathe post

need laps and other tweaks ?

[Racer X]

Sorry Heavycut,

 

I have never been fortunate enough to run a turning center. I wish I could help you out with it.

 

By the way, where in the "good old west" are you?

 

[ 01-20-2004, 02:45 PM: Message edited by: Moto GP ]