World coordinate / WCS wireframe hide toolpath wireframe in 2019

[SlaveCam]

This is a MAJOR issue for me and wasn't prevalent in 2018. Any other workaround than keep pushing F9 key?

[pullo]

The F9 button and "Toggle display on selected operations"  (hide toolpath wireframe ?) are two different buttons, plz explain more.....

Pullo

[SlaveCam]

[pullo]

I don't use the F9 axes , instead I use the grid , a 50 x 50 mm square. 

1. I know if something is the size of a house or the size of a pinhead by visually comparing it to my 50x50 . 

2 at a glance I see my  T/C plane is the same as the hole in the slider...

 

 

[pullo]

And with only F9 in use , I'd be a little lost , as to what is happening on my screen

 

[SlaveCam]

Cool, I never thought of using a grid instead. Got to try how it works out for me.

Kiitti!

[Colin Gilchrist]

3 hours ago, pullo said:

I don't use the F9 axes , instead I use the grid , a 50 x 50 mm square. 

1. I know if something is the size of a house or the size of a pinhead by visually comparing it to my 50x50 . 

2 at a glance I see my  T/C plane is the same as the hole in the slider...

 

 

I also use the Grid for not only size comparison, but placement. Especially since it shows the XY plane, it gives a bit of "orientation" that the Axis Lines don't give you.

[neurosis]

I was used to using a grid before I started using Mastercam so it was a no brainer for me.  When I first saw the f9 axis lines I wondered what in the heck they would be useful for.   

[SlaveCam]

The axis lines are very useful, I can visualize the planes using them, but I may have a brain fault.. besides, I do (almost) all of my modeling in SW.

[Fred @ Slate Industries]

I'm having lines showing then not showing ,there visability flashing on and off as I rotate

Or the mouse gets close to it.

Never happened in 18.