Roeders Programming Guide or Manual

[CarbonCAD]

We are sending some work to our U.K. location and they have a Roeders machine.  I have their post, that works and gives me nc code.  The example they sent me has a .bef file. Is this supposed to post out as well?  The control seems to be a different animal.  Does anyone have any documentation that I could educate myself with.  I contacted the US Roeders and they wouldn't give me any info because the serial number I gave them wasn't in their files.  Probably because the machine is in the U.K.    

[So not a Guru]

30 minutes ago, CarbonCAD said:

I contacted the US Roeders and they wouldn't give me any info because the serial number I gave them wasn't in their files.  Probably because the machine is in the U.K.

Have you tried contacting them in the UK?

[CarbonCAD]

The US guy said I should go through Germany.  I didn't see a UK contact either so I emailed Germany. 

[CarbonCAD]

I did receive a post manual if anyone needs a copy in the future.  It's semi-helpful.

[jlw™]

I'd like to see it.

[crazy^millman]

16 minutes ago, CarbonCAD said:

I did receive a post manual if anyone needs a copy in the future.  It's semi-helpful.

I always collect information if small enough to email my email is in my signature.

[jlw™]

15 hours ago, 5th Axis CGI said:

I always collect information if small enough to email my email is in my signature.

You may be the only person I know who is as bad as or worse than me on collecting and reading manuals.  

[jlw™]

Wait... there's this guy too: