BSmith23
-
Posts
57 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by BSmith23
-
Back to the original question, I don't know if this is related to your issue or not, but I found it was causing issues with my computer trying to do the same thing, check Configuration, Toolpaths, Memory Buffering setting. I don't know how mine got down to 50%, but once I bumped it back up to 80%, I didn't have these issues so much anymore. I happened to see it as a suggestion to another question here, so that's how I found it. Brent
-
Is any one else STILL having fits with containment?
BSmith23 replied to jlw™'s topic in Industrial Forum
Usually, when I run into this issue, it's because I didn't set my Minimum Z Depth appropriately on the Steep/Shallow page. Hope this helps. Brent -
See if this works for you. May have to clean it up a little. I have a link to a free jpg to dxf converter that I do things like this with. Let me know if you'd like it. Brent RHP.mcam
-
The problem I am having is that I don't know what the Post Processor recognizes from what Mastercam defines. For example, In the Cut Parameters page for the Peck Drill Cycle, it only uses the first Peck variable, so I know what the PP calls that. But what does the PP refer to the Subsequent peck variable as? Same for Peck clearance? If I know that, then I think I can get it. Or do I only need to reference what I am calling those spots? If I am using Peck to tell me Pilot Depth, do I just call it Pilot Depth in my PP lines? That's what's hanging me up.
-
So did you put those into the Custom Parameters? Or did you modify the normal Parameters? I am trying to do something similar with my YCM post.
-
We use them here for the S/U views and info for our S/U sheets. That way all we have to do when we get a repeat job is to click on the correct viewsheet, select the correct OPs, and print S/U sheets.
