Another one of those pesky message boxes

[SlaveCam]

Is there a way to turn off globally all work offset checking, whether importing or setting the offset via plane manager. It's none of mcam's business how I assign my work offsets.

And as one would expect, the checkbox "Don't display this message again" does not work. Do they do this on purpose?

[Thad]

I've said it before and I'll say it again. A Form Filler is your friend.

[JParis]

Might want to check the config...this is in 2021

 

[JB7280]

11 hours ago, Thad said:

I've said it before and I'll say it again. A Form Filler is your friend.

Form filler?

[Guest]

 

1 hour ago, JB7280 said:

Form filler?

https://www.rlatour.com/aformfiller/

See the link in thads bio^

I gather it allows you to fill out responses for message prompts automatically, I use something similar.

[JB7280]

14 hours ago, [email protected] said:

 

https://www.rlatour.com/aformfiller/

See the link in thads bio^

I gather it allows you to fill out responses for message prompts automatically, I use something similar.

Interesting.  So it basically just checks/closes the window for you automatically?

[Thad]

On 10/1/2021 at 9:29 AM, JB7280 said:

Interesting.  So it basically just checks/closes the window for you automatically?

Yes.

It will check/uncheck checkboxes. It will click OK, Yes, No, Cancel, etc buttons. The list goes on.

[SlaveCam]

Thanks JParis. Now if only it didn't set the work offset to 0 when importing an operation that uses an offset number that already exists, but I guess you can't have everything.