Error message

[jimp]

Hi all for some reason I am getting this error message on screen. I have a new hard drive and re installed Mastercam.

 

File not Found

 

c:mcam9chooksmcucetops.dll

 

Best regards Jim from Bonnie Scotland

[Thad]

Do you get that on startup? Its sounds like cmucetops.dll is set as your default chook, but it's not in your chooks directory.

 

Thad

[jimp]

No I checked that Chook at startup set to None.

[jimp]

What is mcucetops.dll

Chook for

[Thad]

When do you get the error?

 

Thad

[jimp]

When I carry out and activity in the Operation Manager.

 

Thanks Jim

[Roger Martin from CNC Software]

Could it be refering to? -> MCUGetOps.dll

 

This is a DLL from MCU (MetaCut Utilities)

I would not expect to find it in the CHOOKS folder.

On my system it is located here ->

C:Program FilesMCUPartnersMastercamMCUGetOps.dll

[jimp]

Roger Thanks Copied the file C:Program FilesMCUPartnersMastercamMCUGetOps.dll to the Chook directory why it was asking for this file I don't know but if it stops the error box appearing every time I was in the opp manager thats good enough for me.

 

Thanks again where would we be without this forum.

[cadist]

Hey Jimp, I recently re-installed mastercam from 9.1 then all patches one by one. I encounter with this error if patches are not applied. Do you have the latest patches.

[jimp]

No only the 9.1 Disc. Last time a installed I would have upgraded either from 9.0 or 8.1.

so that most likley isthe problem.

 

jimp