Wirecut Fishtail option

[Rickylim84]

Dear All,

 

Is there anywhere that I can enable the fishtail option in the post processor for PRE-X and also X version wirecut post processor?

 

It will output “R-0” other than the I,J at the fishtail there.

 

 

Where can I modify so that I can output the I,J or R with some value?

 

 

Thank you.

 

Machine: Mitsubishi - PA20.

[edmBosto]

In X2 you can enable it by going into your machine definition under "corners" and then place a check at the fishtale option.

[edmBosto]

double post again!

[Hardmill]

quote:

---

...Evertime I post a question to mastercam, there is no response.....

 

Other CAM Software are STRIKING MASTERCAM HARD!!!

---

Looks like someone helped ya here. :SLAP :EYE GOUGE:

Think before you run your mouth block-head.

 

 

PEACE

[edmBosto]

Is there something going on behind the curtains here?

[Kannon]

quote:

---

Is there something going on behind the curtains here?

---

check out the how to become a programmer thread

[Storkman]

quote:

---

Is there something going on behind the curtains here?

---

If you only knew what went on behind the curtains.................you'd be scared.

[edmBosto]

Just did a search. Now it makes sense.

[Hardmill]

quote:

---

If you only knew what went on behind the curtains.................you'd be scared.

---

:SLAP: Shut up dum-@ss you want everyone

to know bout the %#$@!&. "sheesh"

 

 

PEACE

 

[ 03-17-2008, 01:37 PM: Message edited by: Hardmill ]

[FLIPPER™]

circle? what circle? somebody say something about a circle?

[Guest]

we're not supposed to speak of the "circle"

[Midwest]

J

[edmBosto]

It's been a long week

[Hardmill]

quote:

---

we're not supposed to speak of the "circle"

---

Looks like all you chuckle heads let the cat

outta the bag.

 

 

PEACE

[Midwest]

quote:

---

:SLAP: Shut up dum-@ss you want everyone

to know bout the circle. "sheesh" [Mad] [Mad]

---

 

 

[Midwest]

quote:

---

we're not supposed to speak of the "circle"

---

or

 

 

"The Higher Circle"

 

 

[Chris Parish]

I see Rickylim84 writes a lot of "one liners" in the developers forum mentioning other softwares for comparing to .... interesting

[Steve Zirtzman]

Since you Numskulls let the "Cat out of the Bag"...

I thought we were calling it "The Circle of Trust"?

[Hardmill]

You dope, yer askin fer an :EYE GOUGE:.

We've banned ppl for less

 

 

PEACE

[Steve Zirtzman]

Sorry guys, I guess I'm a little CORNfused. I thought you were asking if we "trusted" the Circle Toolpaths.

$*%#

[Hardmill]

quote:

---

thought you were asking if we "trusted" the Circle Toolpaths.

$*%#

---

 

 

PEACE

[Midwest]

LOL