spade117
-
Posts
803 -
Joined
-
Last visited
-
Days Won
1
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by spade117
-
quote: **bump** huh?
-
accu-snap makes machinable jaws that might be what you are looking for.
-
I have not had any problems with either 8 or 3.
-
what happened to defect #CNC 00013244?
-
I use cimco on everything here.
-
in x it could be a graphics card.
-
in x or off the machine?
-
I don't know why it is doing that, but when you edit you can remove block #'s and then remove empty lines and then put block #'s back in.
-
in regaurds to retention knobs: some of the people here used loctite on them,we have not had any problems. I was always against the practice because we used to interchange knobs between machines. Now we don't have that problem anymore. I have always used a spanner wrench with a soft hammer.
-
I've seen other windows applications do that, but I don't think it is something you can edit. sorry.
-
you could play around with it till you figure out where it is in the post processer.
-
if you left click on the toolpath you can give it a name but the # will not go away. I do this for an explanation to the operator so they know what the cutter is supposed to be doing. I hope that helps you.
-
be more specific.
-
I have had problems, but most of them were resolved by either reading the book or asking on this forum. I don.t neccesarily dislike it but you are right about liking it because I learn something new.
-
is any one using mastercam 9 with an axyz
spade117 replied to GRASSHOPPER's topic in Industrial Forum
the name is good while it lasts -
we just got rid of 2 500's. they could not rigid tap. but the yasnac control was very good and the machine made good parts - just slower.
-
in the parameters of the toolpath you can go to planes and change work offset # to 1 for g55. unless you already fixed the problem
-
No more service packs coming out
spade117 replied to Jeremy Grigsby Excelsior Marking's topic in Industrial Forum
I like cimco very much also, but I'm still at version 4.32- but it works very well for me. -
No more service packs coming out
spade117 replied to Jeremy Grigsby Excelsior Marking's topic in Industrial Forum
so, when all you people updated x did you have to back and change any settings? -
I have mmd files for the machines we use, but for some reason it won't accept them as a selection
-
when I try to set the type of machine that I'm using I get an error that says: Control definition file for machine not found. default control settings will be loaded. I thought I had already configured all my files to x
-
I figured it out, but it was just a new toolpath group, I still had to copy them from toolpath 1 to toolpath 2.
-
why is it that when I start a new toolpath group my previously used tools are not there anymore. It has taken me almost a full day to program a square part with holes in 2 sides.
-
I'm not trying to change the read only files< I thought I was tryin to fix a machine def that I had given the system. No matter what I do I keep getting the same error that I stated above.
-
I tried that, it gives me the warning: the system default machine cannot be edited