duckdogers
-
Posts
176 -
Joined
-
Last visited
-
Days Won
2
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by duckdogers
-
thanks again for your help.I,m not sure where to begin to fix this issue this is the post we have always had so you were right in saying it is an old one.We have just gotten used to working around our problems instead of fixing issues,just the way it works around here some times
-
in the file I posted,if I post the last op I don't get any rotation.If I turn on rotary axis substitution then post I get exactly what I need.I,m not sure what it does but it seems to work.
-
thanks I will have to study this some more to understand I am still green when it comes to rotary work
-
I think I found the problem I turned on rotary axis positioning and it seemed to work does this make any sense
-
hi guys I roughed this piece on all four sides and want do go around again for finish but when I post op5 it don't give me an A0 rotation any help appreciated
-
thanks again
-
thanks john.Question-after the part gets rotated what happens to other planes,does the top not become the front
-
hi guys I keep on getting error on op4 while the other 3 post ok.not much experience with rotary so any help will be appreciated.Running this on a hass machine
-
no that's not the problem.To me no question is a dumb question
-
I already checked that and those are the same settings I have.
-
we have 2 seats of mc7,one seat when you post all ops it s fine on other seat it wont post all unless you highlight all ops and change nci file name.I think one of the guys has changed something by mistake because it never used to do that.Would anyone have any idea how to fix it
-
seems it came back on today.machine retailer says the monitor is getting tired and will need replacing soon
-
yes it does but I have never seen this before.When you push the prog button it stays black when it should be showing something
-
I am running a job dnc on a hass vf3 I just went to check on it and the screen was completely black but its still running.Any thoughts,personally I think the screen is pooched.
-
I would say if the setup is big and the orders are solid it makes no sense to me to turn around a month later and run the same job when you can run it now.Just my opinion which a lot of times mean squat around here.
-
thanks guys that's exactly what I needed
-
hi guys, I am trying to create points where the green lines intersect at the surface but not quite sure how.I have been trying for an hour now and can,t figure it out.
-
if clearance is set at .05,retract at -.590 it should work.I never have it rapid down to start point(in this case -.64
-
I would put the retract at -.590
-
thanks I will give that a try
-
its ok I figured it out but how do I add depth cuts
-
can someone please tell me why the cutter won,t go to the bottom of the groove(level4)I have done this before but cant remember how Thanks
-
hi guys I have to make this part not sure how to go about it.I was thinking of doing the bottom first then fixturing it so I can hang on to it to do everything else .we have rotary axis here but I figured I wouldn't need it with a fixture.Its is ht p20.Any thoughts,Thanks
-
I certainly agree
-
I have also had problems with containment but have been able to work around it
