quote: its a nice feature to have is it on any wish list at all? I certainly hope so. That way you can go from one project to another without closing Mastercam all the time. It works in a lot of other software already

gcode, So it only supposed to work when you drag the file onto your desktop Mastercam icon? Not just dragging the file into the display area of Mastercam once it is already open?

Bump

Ok, any idea why it doesn't work here?

Has anyone figured out whay this does not work on some computers? Wish it did work, especially with dual monitors

This is what I am getting Cannot Create Arc Tangent 3 Lines

Has any one noticed an issue with creating an arc tanget to 3 lines? If I draw 3 lines and then go directly to Create Arc Tanget, pick either one of the icons for creating an arc tanget to three lines it works fine, on the other hand if i try and create and arc to lines that are already in the screen,it will not create an arc. The lines are on the same plane and they are lines and not splines.

Faster Than What?

Everyone have a save and Merry Christmas. And may year 2007 bring you joy and happiness!!! Thank you guys for all the help, laughter, and comments. See ya next year, I'm outta here.

Adam, We use Cimco DNC-Max and it out performs anything that we have used before. Reliable and the service after the sale (which is very important when you have an problem) is unbeatable. I would higly recommend Cimco.

quote: Looks like a drinking party in here.... LOL!!! Mark I was thinking the same thing.

Sorry too slow( I must be still full from yesterday.

Does not seem to be working today either(must be still full from yesterday). quote: What is this patch for?? This is from the website. This patch is issued to address an Update Manager error:

Jeff, The book says 30-60fpm. Good luck on tapping that deep with a #4 tap. HTH