Matsuura 1000vf yasnac i-80 look ahead code

[?Mark]

Matsuura 1000vf yasnac i-80 look ahead

 

Does anyone know if it's available and what the code to turn it on would be?

Spent couple hours combing thru the books with no luck and I find it hard to believe it'd not be available ???

 

TIA!!!

[Allan]

The i-80 control has the standard 3 line look ahead (always on), or exact stop (G09), take your pick.

 

Allan

[Buddy J]

I don't know about any specific codes avaiable but on our Kitamura Horz's w/ yasnac i-80s

for HS (look ahead) machining in comp what we were either told or found, (its been years) was

to put in ON/OFF commands as follows

 

N9X1.3Y-1.024

Z-.46

GON

G41G1Y-.649F135.D52

X-2.61

Y.482

X.93

Y-.649

X-2.61

Y.482

X.93

Y-1.024

G40X1.3

GOF

N10G00Z2.

 

Pain in the butt but it definately made a difference.

note: letter O, (not zero) and once the GON is read, the screen will stop scrolling

untill the GOF is read.

 

Hope this is what you were looking for

[?Mark]

Thanks guys,

If it's always on then it's not very good...I'm constantly fighting with finishes at higher feedrates while surfacing...

I did see something with HON and HOF in the books though

I guess I'll just leave this machine for simpler stuff

Thanks

[Allan]

There is an optional Board avaiable for this machine JANCD-FC251 DTN1018O I NC program analysis (with high-performance INTEXB2 CPU)

So if you have that board in the control the GON GOF stuff will work.

 

I found a good manual here http://www.yaskawa.com/site/dmcontrol.nsf/link2/TKUR-5EKMBT/$file/TOE-C843-11.2E.PDF

 

 

Allan

[Guest CNC Apps Guy 1]

I've only ever seeon HON and HOF.

[gaijin_2007]

+1

HON and HOF if I recall correctly.

[Mick]

I used to programme and run a Matsuura 600VF. The Codes were HON and HOF. The HON went before the first linear move, and the HOF went after the last linear move.

 

Worked nicely too.

[?Mark]

HON is what the book says. I tried it and it gives me an alarm so it's not there. Getting a quote for a board as we speak.

Thanks everyone!

[Sticky]

HON is what the book says. I tried it and it gives me an alarm so it's not there. Getting a quote for a board as we speak.

Thanks everyone!

 

Hi Mark, I am wondering if you got pricing and availability for this Yasnac i80 option. I just purchased Mastercam and an HMC with Yasnac i80 and may be interested in doing the same.

[?Mark]

Not available/supported... Yasnac thing

[Sticky]

Bummer, so was it Matsuura or Yasnac saying this is NLA?

[?Mark]

Local reseller, I think...

[CADCAM3D5AXIS]

try doing a e-bay search for the part number a lot of stuff left on a shelf somewhere may just turn up we have had luck finding parts that are NLA Good Luck

[Guest CNC Apps Guy 1]

THe final arbiter in the states woudl be Methods Machine Tools in Boston. GIve them a call.