The New Verify

[crazy^millman]

Rick that is the only thing some people seem to get. Can have hundreds of words, but without a picture many don't understand how to do it.

[Thee Rickster ™]

Thanks Ken

 

But Chris at In-House steeeeeeered me in the right direction!

 

The great thing about knowing this is that when you have a compound angled WCS

that you programmed from and have to verify from, now you can turbo it.

 

Could Not in X6

 

Sweet!

[Newbeeee™]

Hey Rick - What's that bit of welding wire doing stuck out from that holder???

[Thee Rickster ™]

Wire EDM....

 

Lol

 

1/8 ball 1 deg carbide diesnk

5-1/4 " stick out

I difined it a bit longer though.

[Müřlıń®]

I thought I did??

Either way Here is a screen shot of my verify complete (X7 straight out of the box) no html file tweaks.

• All I did was pushed both sliders to MAX
  
• hit the END button in pic
  
• the progress bar moves slowly but surely across to the right side(only took about) 40 seconds
  
• as it is doing so it does not show you the stock cutting
  
• when finished the finished verify shows like what you see in my picture
  
• I also shorten a tool by 2 inches to make sure that this method will show the holder gouge
  
• now you can window zoom with the accuracy of accurate zoom without all the hassle of
  

redoing it over and over with a chopped up block each time

• I guess I stumbled on to TURBO MODE????
  

 

Rick what's up with the z axis?? Or should I say what's down???

[Thee Rickster ™]

Bottom WCS

A (mold) Slide would put z sideways or on a compound angle or what have you.

[jonw]

Is there a way to reset the verify settings. My verify has defaulted to max precision and a couple of the stop conditions are always checked when I first start mastercam.

[crazy^millman]

If in MU1 or above yes. Change what you need and save to defaults. If not then be best to get a hold of your dealer so they can tell you which files need to be deleted. You can always uninstall and reinstall, but a pain.

 

HTH

[jonw]

I must be blind today as I keep looking over the save buttons, thanks.