BOUNDARY VIOLATION! ARRGGGHH!

[Tinyfxds]

It would be extremely helpful if Waterline lead in and lead out moves would respect boundary limits.  I can't tell you how dangerous this is when a Waterline tool path decides to arc on / off into solid stock, which was not cut out because the Area Clearance tool path was limited by a boundary.  The same boundary I'm using for the Waterline tool path I might add.  I'd like to be able to rely on these boundaries to limit ALL tool path moves.  I know I can control my leads but this should be a feature that's baked into Mastercam.  After all, Area Clearance and Dynamic tool paths respect boundary limits.  Why can't finishing tool paths.  Am I missing a setting somewher?  Ok.  Rant over. 

[Teh Bear without Brains kinda idiot]

I wonder what is your trim to stock settings ?

[Tinyfxds]

I don't normally use trim to stock.  I guess I wasn't aware that this could limit lead in/out moves in relationship to a bounary.

[Thad]

So, trim to stock fixed it?

[Tinyfxds]

I haven't had time to test it out.  I will try it out shortly.

[Tinyfxds]

FYI - Trims to stock did not work with limiting the lead in/out moves.

[SpacePilotPro]

_{I have found the "trim" feature in the toolpath menu to be effective in stopping all toolpaths.}

[Jayson Kramer]

use a stock model to see what is there in the waterline path and it will avoid it.