Leaderboard
Popular Content
Showing content with the highest reputation on 12/23/2020 in all areas
-
Hot Damn! That's just what I was looking for! And thanks for the other tips guys!1 point
-
its the Cplane vs 3d setting in the solid chaining manager, change it to 3d and it will select just the single edge, see gif below.1 point
-
The easiest way is to turn off "face" mode and just use "edges": If you want the convenience of both on, then just be a bit more careful about where you click. Clicking with your mouse over the face like this will select all 4 edges of that face (Face mode). Clicking when your mouse is over only this highlighted edge will select only this one single edge.
1 point -
Here's a tip... When you're in a full chain and you only want a part of the chain.....click the chain(it will close the loop) then select that past piece of the chain you actually want(it will revert to partial)1 point
