TOOL SPEEDS AND FEEDS

[chris connelly]

Tool speed and feeds will not change when i change tools is there a setting for this and where can io find it

[TREV]

right click on tool in operation parameter page and select reinitialize feed and speed

trevor

[#Rekd™]

Right click on the tool and reinitialize speeds and feeds.

[Guest]

11 minutes ago, chris connelly said:

Tool speed and feeds will not change when i change tools is there a setting for this and where can io find it

Uncheck lock feedrate in File -> Config -> Toolpaths

[huskermcdoogle]

8 hours ago, Thee Byte™ said:

Uncheck lock feedrate in File -> Config -> Toolpaths

That setting has burned me so many times......   I will forever have that checked unless somehow I only do the same thing over and over and cease to care about optimizing my feeds and speeds per operation and cut width/depth.  Which will likely be never...

[neurosis]

6 minutes ago, huskermcdoogle said:

That setting has burned me so many times......   I will forever have that checked unless somehow I only do the same thing over and over and cease to care about optimizing my feeds and speeds per operation and cut width/depth.  Which will likely be never...

It would be nice if you could lock it per operation rather than globally.

 

[Leon82]

22 hours ago, neurosis said:

It would be nice if you could lock it per operation rather than globally.

 

Yes. Put a little lock icon or check box next to it.

[chris connelly]

thanks for the help i found the button 

[Guest]

On 3/11/2021 at 11:04 PM, huskermcdoogle said:

That setting has burned me so many times......   I will forever have that checked unless somehow I only do the same thing over and over and cease to care about optimizing my feeds and speeds per operation and cut width/depth.  Which will likely be never...

I do the same