b_daddy
-
Posts
192 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by b_daddy
-
Heavy and brendan, You guys work at the same place I do? This sounds way to familar. How come we don't get raises?, How come we have to pay for some of our health costs?, How come we don't get any new machines?, whine ,whine ,whine. Its pretty obvious why these things aren't happening. Another gripe, I can't run two machines, I'm to busy holding up the bench or talking to joe shmoe
-
This has been a pet peeve of mine for a long time. Cells phones are not allowed (which is the way it should be), but if you don't get caught, you're fine. As for the late issue, around here they say " at least they showed up". What kind of way to run a business is that!!!??? I wish they would send them home for a couple days.
-
Go ahead and load it. I got both on my computer and no problem. I'v done the same thing as Jimmy suggested, draw on X, post in 9
-
Is it a straight gear? If so can you put two rolls across from each other and mic over them and put that info into the roll dia. and the dim. across pins section of the chart?
-
ktd Do you have any more information then the number of teeth an o.d..? The chook usually works good if you have all the info.
-
This one has probably been asked before, but can't seem to find anything How can I make the toolbars stay put in one spot, without moving all over the top of the screen?
-
polishman Create / Arc / Arc Tangent / Then in the Ribbon Bar the 4th Icon from the left, I believe is what you are looking for. I would put screen shot up but not familar with how to do that yet. HTH
-
gcode It goes to show you Mastercam is worth more that AutoCad
-
Thanks jmparis I have that reference card, I guess what I was looking for is after you do some custom key mapping, is there a way to show all the changes you have made without wriiting them down somewhere? Thanks again
-
Thanks jmparis I have that reference card, I guess what I was looking for is after you do some custom key mapping, is there a way to show all the changes you have made without wriiting them down somewhere? Thanks again
-
In v9. hitting F10 gave you all the buttons that were assigned to hot keys. Is this in X, if it is where? Thanks
-
Roger, I have the same issue as Chuck. I am saving the file to our network which I do admin's rights. I also cannot get to the link that you have posted. Any ideas? Thanks, Bryon
-
Lee, Are you using X or V.9 In V.9 try and uncheck the Cutter Radius for 3d cutter compenstion. HTH
-
John+ There is a thread on the forurm discussing this same topic. I have both installed on my computer and have had no problems at all. Just the learning curve.
-
Tim, When I talked to them last week they said the invitations were going to be sent out last week or this week
-
Michigan Mastercamers Call your salesman I did and had mine the next day
-
Jeff, Won't get it till the middle or end of Sept. either.