Service pack update 3 is available

[?Mark]

We need a guinea pig

Any one willing to try it?

 

Mark

[DavidB]

Not me

[malibu]

me tampoco

[DGreeves]

That's funny Mark

[HevyMetl]

I backed out of 2, and I think I will wait to see how 3 goes before I load it.

[?Mark]

O'k

Guinea pig reports no problems so far.

 

Tried it on several files and see no issues

 

Mark

[Fred @ Slate Industries]

My Hasp driver update is erroring out

 

"Unexpected setupapi function failure

Error code 14 , 2672

 

Help me....

 

Edit: I had to Re boot, all is well

[gcode]

Tony.. did you get that SolidWorks problem fixed??

[?Mark]

O'k

Guinea pig reports one problems so far.

When going to update manager I get a massage "The update manager could not locate correct version of mastercam on your machine. You might need to run a repair..."

 

Mark

[DavidB]

I need a massage

[?Mark]

[Fred @ Slate Industries]

G code,

No, I had too log that one over there.

I have identical settings as some others at work,

Only I share a Net Lic. with the owner who only uses it for undercut detection once a week

Thanks though.

Tony

 

(It just goes to show you Nothing is Bullet proof

right out of the gate in this area)

[Grant Moiler]

just loaded update 3, also fixed the hasp driver so i've got 9.1 back again, i'll wait to see what happens

grant

[?Mark]

Grant, can you go again to update mastercam on your pc and see what happens ?

 

Mark

[Thad]

Mark,

 

One day I was just goofing around and I checked for updates when I new I had the latest. I got that message that you mentioned. I didn't reinstall because there was nothing wrong. Then update 2 came out and I updated on that same computer with no problems. Well......

 

Thad

[?Mark]

Magic

 

Mark

[Grant Moiler]

Mark, i got the same message "The update manager could not locate the correct version of Mcam X....." The MCPost.dll and VersionChecker.dll say 10.0.14.31 which is update 3

[?Mark]

nice

 

Thanks for checking Grant

 

Mark

[Hrubes]

Same as Mark Bana

 

The update manager could not locate the correct version of Mcam X.

[RandyN]

I downloaded it, and installed it with no problems so far.

[Bill]

quote:

---

Error

 

Perhaps you need to select a proper machine definition, or perhaps your simm is not enabled for the necessary product level.

---

I will try to reboot.

[Steve Zirtzman]

Downloaded from direct link and installed with no problems.

[Bill]

Reboot fixed the error.

[tooljockey]

I have tried to download Update3 four times now and I keep getting a "Installshield" error...

"1628:Failed to complete installation"

I just gave up. I'll wait for MR1!

 

My 64 bit system might have something to do with it?

[Slepydremr]

quote:

---

When going to update manager I get a massage "The update manager could not locate correct version of mastercam on your machine. You might need to run a repair..."

---

Same problem here. But I'll take this one over the posting issue any day. At least this one doesn't confuse the hell out of the operators