Register now to participate in the forums, access the download area, buy Mastercam training materials, post processors and more. This message will be removed once you have signed in.
Use your display name or email address to sign in:
Mark,
These people make Femtosecond lasers for hole drilling.
There is an article about drilling holes in injector nozzles in
the current issue of Laser Focus World.
Here is a link to the company that sells the equipment. http://www.raydiance.com
hope this helps.
.
.
35k
Gcode,
Big Kaiser has hsk 125a.
the spindle inter face has 11000 foot lbs of holding force!!!!!!!!!!
big and strong. you will like them when you see them in action.
.
.
35k
Gcode,
I have the DNC-DT, Supernerbs, glass scales. and the micron option (0.0001mm 0.00001in).
after 10 years it still holds all its precision like it was new!!!!!!!! OKUMA is always my first pick.
.
.
35k
Jamman,
Here are the Harvey tools i use 75102 & 75102-c3.
they are runner 2 flt cutters i run at 35000 rpms @ 43.75 ipm @ 0.003>0.004 doc
in aluminum.
.
.
35k
CAUTION do not try to turn a spindle motor rated at 12000 rpm at 24000 rpm!!!!!!!!!!!!!!
you will damage the bearings, the motor will over heat, the balance of the spindle will not handle 24000 rpm
and it could explode. THE MOTOR AND VFD MUST MATCH !!!!!!!!!!!!!!
.
.
35k
Millertime,
check your Y axis limit switch it might have coolant in it or a loose wire.
I had this same condition about 3 weeks ago. had to replace the X axis
micro switch under the table.
Just a thought.
.
.
35k
eMastercam - your online source for all things Mastercam.
Together, we are the strongest Mastercam community on the web with over 56,000 members, and our online store offers a wide selection of training materials for all applications and skill levels.