-
Posts
759 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by [email protected]
-
Select custom drill cycle and set your peck depths and then go back and select peck drill HTH
-
It should be in the machine def under "Tolerances"
-
quote: I heard that they are working on it... I heard that too Leigh
-
+1 to MCU and its free to maint. customers
-
Cool Links. Thanx bigjohn
-
What I do is, put comments in the tool page of parameters and it posts out in Parenthèse. I dont know if you're lookin for a different way, but this will work. HTH edit:
-
There is a very good explanation of macro here: http://www.emastercam.com/cgi-bin/ultimate...ic;f=1;t=037194 HTH
-
I've noticed it's alot closer to real time when you dont have drill ops in it HTH
-
Toilet Paper? -
On your tool page of parameters does it by any chance say "Repaired NCI"?
-
You'll just have do look back in this thread.....it's only 30 pages
-
Under "Type" you can pick "Translate", "Rotate" or "Mirror" HTH
-
quote: That action might attract an undesired visitor. ^^Or a friggin RAT^^
-
quote: going on and on As the pot said to the kettle
-
The tool holder in your pic, how many patents did you violate? Alot of people make one similar to yours
-
I'll do one with 8 grips and call mine TechMO Grips......that will keep the "Patent Lawyers" off my butt And yes alanu's got a cool thing goin on
-
Thanks for the link peon. I work with a lot of D-2 and this might come in handy some day
-
IIRC, 7.2 is pretty close in age with ACAD 12
-
Can you save it back as far as version 12 dxf?? If so, I would try that HTH
-
Try HST Horizontal HTH
-
Direct Reading Precision Square
[email protected] replied to Rob @ Target Machine's topic in Industrial Forum
quote: we use a cylinder square daily Here too.....thats why I wanted to buy it. The shop has one, but I would like one of my own -
Could use insight on some post modification for Hurco
[email protected] replied to parkerbender's topic in Industrial Forum
Tony, I do have the ISNC option, just never used it. I would like to try your post. khorton(AT)murraymold(DOT)com Thanks Tony -
Direct Reading Precision Square
[email protected] replied to Rob @ Target Machine's topic in Industrial Forum
quote: I was pretty sure it was a paperweight ya wanna sell it? -
Change Logo on X-Plus Setup Sheet
[email protected] replied to Todd Tracey from Fastech's topic in Industrial Forum
Ken, I just quit using our Co. Logo....it looked cool, but we all know where we work -
Could use insight on some post modification for Hurco
[email protected] replied to parkerbender's topic in Industrial Forum
When I have to drill on different planes, I use a "Point" toolpath to make it rapid down to the plane I want to drill at then do the drill op. It works, but more time consuming. Hurco drill cycles SUCK!!!