I hope they never do away with my favorite MC feature.. the "End" button spin mode..

[RandleXX]

Not sure what it's for, but it sure is sweet! I use at least a couple times a day..

 

Woohooo... spin around and around...

[Jayson Kramer]

Been there for over 20 years yeehaaa

[Brian B 74]

Never heard of it. Never used it. What does it do?

[RandleXX]

Just Push the "End" button on your keyboard and watch your model spin.. round and round and round...

[Reko]

That was fun.

[TK-32™]

it's cool when you put the part outside the screen and it makes it's way to the center.

[mayday]

quote:

---

it's cool when you put the part outside the screen and it makes it's way to the center.

---

just like a toilet

[ATG]

And its not even Friday........

[Thee Rickster ™]

Its flawless.

[clyde]

i use to get that going and leave, it drove the night shift guy crazy trying to figure out how to do it. i don't think its in the manual.

[Oppiz]

When training people I sometimes tell them after a long programmed part to hit the END button. Then when things start spinning, they usually say "what did I do?" I mess with them and tell them that they screwed up the whole program and need to start over.

[Josh Kinney -Elite Engineering]

Thanks for the humor! I needed a good laugh!

[Programinator]

The faster it spins the better your graphics card is.

 

Mine dont spin very fast

[3R!< W3NG3R]

Try a smaller part.

[Programinator]

a little bit faster now....a little bit faster now.....a little bit faster now

[Nick Eaton]

quote:

---

Its flawless.

---

Truely funny.....and it works on so many levels......get it!!

Cheers

Nick

[Roger Peterson]

Does it spin the opposite direction in australia?