Register now to participate in the forums, access the download area, buy Mastercam training materials, post processors and more. This message will be removed once you have signed in.
Use your display name or email address to sign in:
I would use dynamic or pocket highspeed which ever is faster. I would try both high step over shallow cut and full depth light radial and see the time difference.
then a separate zigzag finish pocket at final depth to get your floor finish.
our dealer did this with a post for our feeler pallet. it was done with a flag
when m62 is put in the manual entry to signify pallet 2 it switches output to m62 for each tool change
this is to prevent misoperation. you have to try hard to run the wrong pallet
this is a snippet of the tool change block
if pallet_flg = 1, pbld, n$, "M62", "(PALLET B)", e$
else, pbld, n$, "M61", "(PALLET A)", e$
There is a line if1021=1goto300
Return from mc in the 9002macro. It's on that line I think when it empties the machine when I try a quick dwell program
35v
It's brand new. I can grab the date tomorrow.
Yes it's not in standby mode as far as I know the program #1 ends. It shuts down and then the automatic timer starts the machine back up.
Our other 35v never leaves the machine empty.
If I turn the coolant neglect button on I can run the warm-up program while it's empty
after the last pallet in the que is run it puts it in the pallet rack leaving the machine empty. it gives an alarm about coolant I'm guessing because the draw mechanism is exposed
I used a sandvic heavy metal arbor for a job. I got 9 inches of reach if I recall. I held it in a nikken slim chuck.
It had all sorts of heads you could screw in
If it's an angles wall Mastercam will average it out as you are telling it 2 different stock to leaves for that feature.
You can use a containment boundary to controller wall stock also
The fine print on the kitamura says basically you need to have it in a lab.
We have all matsuuras and anything with a true position of less than .002 we usually make a probing sub program and not use the tilted work plane. It has no problem holding with the probes.
i would get the 520 over the 330.
We have 2 one with the manual guide i and one with the ihmi control. When running a program from Camplete this isn't a problem because with all the twp command it eats up some time.
But if I'm probing at a0 then come up to a90 and clamp and probe more. The a axis load meter climbs upt into a servo alarm with the disconnect error. Matsuura has a bulletin for it and they came and adjusted it. But it still happens. We run out machines at 50% rapid. If you go to 100 it gets worse. If I put a dwell before the clamp it doesn't happen.
eMastercam - your online source for all things Mastercam.
Together, we are the strongest Mastercam community on the web with over 56,000 members, and our online store offers a wide selection of training materials for all applications and skill levels.