MACHINEMASTERG
-
Posts
1,216 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by MACHINEMASTERG
-
yea any thing like this for haas ???
-
we had level 2 at first and in a short while we had to upgrade to 3 to really do the things we need
-
we use our presetter only for turning or groving tools like chris said for our drills or tap positions we sweep the turret position and recorded that location this will not effect the setter and for our tool change we send it home first ..g28....
-
mag chips in the outside fire pit ...then spit streaming water on it and watch peoples faces they swear its gasoline then drink it down they dont know what to think ....
-
sounds like a lemon to me... weve had only good machines from HAAS, 10 in all, mills and lathes and anything that might have gone wrong we have fixed ourselves there quite simple to work on ...now my buddies shop had nothing but problums with there daewoo lathe so you never know ???
-
solidworks 2008
-
so do we and thats what this weiler co does also ...i was just wondering ???
-
scott a little highjack but are you part of the weiler company in moorestown nj ?????if so we build conveyors for you guys just wondering???
-
what no haas ???
-
Debate on Contour ramp milling versus depth cuts
MACHINEMASTERG replied to Todd Mann from Fastech's topic in Industrial Forum
RAMP .RAMP.RAMP...we like ramp -
a dwell in the hole while in contact with the material will cause work harding
-
i would also start out with a stub drill go as deep as posible then step up to the next longest drill a taper lenth drill has an overall lenth of 7.75 that should do it the drill your using is kinda long
-
prism eng in pa is the best!!! even without phil(the man)
-
Off Topic - vacuum channel gasket
MACHINEMASTERG replied to tangent dynamic's topic in Industrial Forum
Awsome site how many of you other guys are using some form of vacuume holding ???We have done some on plastics with limited success ..... -
we cut 316l all the time also we find that high speed milling works best for us ..light deepth of cut at higher feed rates ..tialn coated carbide maybe .015 deep at 50 to 75 ipm
-
i had a smartcam class in school and it had a macro feature that the teacher could see all your key strokes and how you did the part
-
haas only dog legs in rapid whats the problum with that ??we never had any here ???
-
keyless here for many years
-
Kirk EMMONS is that you??? my long lost brother ??????j/k ..welcome to the family and the forum
-
WE TAP 3/4-10 thru 304 stainless steel in our mini mills all day long ...we HAD guys here that would blame the machine for there short comings i would do the same jobs with that same haas with good parts all day long ...sometimes its the man not the machine .. a good machinist can make anything work how about all those years the manual bridgeport was king
-
NObody really ripped them here but any other time you get negitive responces about haas or fadel we should support made in usa machine tools ..my company could afford a higher end machine but we have all haas machines 10 in all, mills and lathes some with pallet changers and we cut 316 and 304 stainless steel all day and night long with no problums whatsoever ...HAAS ROCK
-
hold down with double face tape ... but i doubt if that will stop the warping
-
im no expert but it only does what you tell it if you put xyz on the same line it will rapid xy in a dogleg and be going to the z value all at the same time you have to break up the z move to the next line ...
-
get well
-
sw and mcam here also