Register now to participate in the forums, access the download area, buy Mastercam training materials, post processors and more. This message will be removed once you have signed in.
Use your display name or email address to sign in:
Can confirm. not always but this does pop up occasionally. Should be an empty place to select nothing for simulation. one of my guys spent hours trying to figure it out before he asked the question. 5 axis pgm he was set at 3axis in simulation. We use vericut. (facepalm)
I prefer to leave it blank and pick the machine from the drop down menu AFTER saving the blank file. Populates the machine group, toolpath group and NC with the mastercam file name. (which is our program number)
https://www.emastercam.com/forums/topic/104842-simulator-2022-bugs/#comment-1332823
I always have to reselect stock in "simulator options" button every time I open a new instance of an old program. It's routine now.
We would cut down the center taking full advantage of the upper corner rad tolerance, cutting it as wide as possible, We also make our own dovetail cutters and making the dovetail cutter O/D -.002 smaller than the slot and maxing out the lower rad makes a beefy tool, we historically only use one finish pass each side. (operators digression to re-run the tool if needed).
MATERIAL REMOVED BY RADII.xlsx
not automatically, could revolve a solid on a helix. but IMHO importing a screw from McMaster align to your minor and boolean remove it is waaay faster.
refractometer.
Not here, But at my shop I used to use Castrol Hysol synthetic cutting fluid, was clear (could see thru the windows) and did not go away and would cover the walls. after the tank was low you could just hose off the walls inside with water and bring the level back up checking with a refractometer (recommended reading of 9). adding more fluid if needed. having it coat the inside of the machines there was no corrosion. just hose it down in the am not before you leave for the day. (your coolant supplier can recommend the concentration %) think refractometers are still under $100.
replaced a HDD added our cloned drive. VERISURF TOOLS comes up. but can't enable our REVERSE. works fine on everyone else's. although it shows on the tab as VERISURF TOOLS not VS TOOLS. licece is good. and says were good but tab won't show. any suggestions?
eMastercam - your online source for all things Mastercam.
Together, we are the strongest Mastercam community on the web with over 56,000 members, and our online store offers a wide selection of training materials for all applications and skill levels.